Product Information
Categories: BURNERS, OVENPAK 1MAXON pilot orifice valve for the Ovenpak 2 allows for minute adjustments to the pilot capacity to ensure reliable and strong lightoff under a variety of operating conditions.
- Brass body construction.
- 3/8″ threaded inlet and outlet connections.
- the orifice is available in both standard and high capacity models.
Related Products
SPARK IGNITOR – OVENPAK 2
MAXON spark ignitors have been engineered specially for industrial burner applications. Quality construction provides maximum service life and dependable operation to keep your heating process running smoothly. Consult technical bulletins to ensure your setup is per manufacturer`s recommendation for your specific OP2 model.
MAXON FLAME ROD – OVENPAK 1
MAXON rectification rods (flame rods) for the Ovenpak 1 have been engineered specially for industrial burner applications. Quality construction provides maximum service life and dependable operation to keep your heating process running smoothly. Consult technical bulletins to ensure your setup is per manufacturer`s recommendation for your specific OP2 model.
DOWNLOADS:
MAXON BRACKET & LINKAGE – OVENPAK 1
MAXON linkage kits allow for the direct coupling of the internal air/gas butterfly valves of the Ovenpak 1 burner series.
GAS INLET GASKET – OVENPAK 2
MAXON gas inlet gasket is to be installed on the gas inlet flange of the burner casing. Designed to provide an gastight seal around the inlet flange of the burner casing, this gasket should provide a worry free seal under a variety of environmental conditions. The gasket is considered a consumable item and should be replaced during regularly scheduled burner maintenance.
MOTOR BRACKET – OVENPAK 2
MAXON Connecting brackets and linkage assemblies are available in 4 main versions:
- Maxon SMARTLINK DS drive motors.
- Honeywell MODUTROL drive motors.
- Honeywell HERCULINE drive motors.
- Barber-Colemand drive motors.
Special assemblies can also be engineering upon request.
MAXON BLOWER GASKET – OVENPAK 1
MAXON blower gasket for the ovenpak 1 is to be installed on the discharge flange of the integral combustion air blower. Designed to provide an airtight seal around the outlet of the blower flange, this gasket should provide a worry free seal under a variety of environmental conditions. The gasket is considered a consumable item and should be replaced during regularly scheduled burner maintenance.
Oops! We could not locate your form.
GUIDE TUBE – OVENPAK 2
MAXON guide tubes allow for the simple installation of either UV flame detection cells of flame rods. Designed to penetrate through the entire burner to visualize the flame directly of the nozzle tip, the carbon steel guide tubes are available with either NPT or TEC end connections.
MAXON INTERNAL LINKAGE KIT – OVENPAK 1
MAXON linkage kits allow for the direct coupling of the internal air/gas butterfly valves of the Ovenpak 1 burner series.
The kit includes:
- Butterfly dics
- Linkage arms
- Pins
- Seals
- And bushings to allow fo the complete replacement of the control internals.
MIXING CONE – OVENPAK 2
"MAXON mixing cones are availble in 3 versions:
- Standard cast iron mixing cone, suitable for most process applications.
- Excess air cast iron mixing cone, allowing +/-10% more air through the burner with the same overall pressure drop.
- Stainless steel mixing cone, suitable for high temperature or highly corrosive applications.
BURNER SLEEVE GASKET – OVENPAK 1
MAXON burner sleeve gasket is to be installed between the main burner flanges and the oven wall. Designed to provide an airtight seal around the burner flange under the most extreme conditions, the burner sleeve gasket must be installed on all applications with position combustion chamber pressures. The gasket is considered a consumable item and should be replaced during regularly scheduled burner maintenance.